Ear Training with Moleskin and Tape
Apply skin bond to inside of ear with brush.
Allow to air dry to tacky about 3-5 minutes.
Cut to size moleskin is applied from the bottom to the top.
Shows position of the moleskin just above the wrinkle.
Make sure front of ear is not attached.
With 10-12inch piece of tape, start the wrap making sure front
of ear is flat under the tape.
Go around ear and aim downwards, as you begin towards the
front angle upwards.
The wrap is kept loose, NEVER stretch the tape and never pull it tight.
Gently press the loose tape until it becomes snug to the ear.
Wrap the second ear with tape being applied in the opposite direction
as you did the first ear.
They should resemble this.
Fold duct tape three times and cut an angle on both sides.
Measure the wedge so it fits between the ears.
Apply a half width of duct tape to extend over the wedge.
Attach one end of tape around right ear, keeping wedge in position.
Wrap remainder of tape around left ear.
Apply tape to the back of the ears in the same manner as you
applied the front. End results should have the ears standing
equally and well balanced.